21
ABB i-bus
®
EIB / KNX
Commissioning
The following section describes the parameters for the output of threshold 1.
They also apply to the output of threshold 2.
Fig. 14: Parameter window “Channel A – Threshold 1 output”
Send threshold value object
Options:
after a change
after a change and cyclically
This parameter is used to specify the send behaviour of the threshold
value object.
Option
After a change
= Send threshold value object after a change
Option
After a change and cyclically
= Send threshold value object after
a change and cyclically.
Note:
The threshold value object is sent cyclically until
the value falls below or exceeds the other limit.
The following parameters appear when this option is selected.
Send if threshold value falls below every
Send if threshold value exceeds every
Options:
5 s/10 s/30 s/1 min/5 min/10 min/30 min/1 h/6 h/
12 h/24 h
These two parameters are used to define the point in time at which cyclical
sending should take place after the value falls below the lower limit or
exceeds the upper limit.
3.2.2.4 Parameter window
“A – Threshold 1 output”
