ABB ACS850-04 series, Hardware Manual

Page: 79 / 164

Installation
79
Installing the mechanical accessories into the cabinet
For frame G1, see the assembly drawing on page 81 . For frame G2, see the
assembly drawing on page 82 . Install the mechanical accessories into the cabinet as
follows:
1. If you use a bottom plate, make the bottom plate according to the dimension
drawing on page 150 ) and install the bottom plate on the bottom of the cabinet.
Note: If the thickness of the bottom plate is not 2.5 mm (0.1 in.), adjust the
dimensions accordingly.
2. If you use Rittal support rails (TS 4396.500), install three support rails on the
bottom of the cabinet, see also the dimension drawing on page 145 (frame G1) or
page 149 (frame G2).
3. Install the pedestal guide onto the bottom plate (or support rails).
4. Install the Rittal punched sections TS 8612.610 (5 pcs) and TS8612.140 (3 pcs).
5. Install the air baffles (see page 83 ).
6. Install the top guide plate.
7. Install the output cabling panel. Note : After you have installed the output cabling
panel, you can remove the support rail that is under the panel if there is not
enough space for cables.
8. Install the side guides to the output cabling panel (2 screws for each side guide).