ABB ACS580-07, Hardware Manual

Page: 267 / 288

Note:
The support part is needed for the following frame R1 drive types -02A7, -03A4,
-04A1, -05A7, -08A5 and -12A7.
3. Make sure that there are no signs of damage.
Installing the module
See section Installing optional modules in chapter Electrical installation .
￭ Electrical installation
WARNING!
Obey the instructions in chapter Safety instructions . If you ignore them, injury or
death, or damage to the equipment can occur. If you are not a qualified electrician,
do not do electrical work.
Make sure that the drive is disconnected from the input power during
installation. If the drive is already connected to the input power, wait for
5 minutes after disconnecting the input power.
Necessary tools and instructions
• Screwdriver and a set of suitable bits
• Cabling tools
Terminal designations
For more detailed information on the connectors, see section Technical data (page 270) .
Relay outputs
Description Marking
Common, C RO4C 50
Normally closed, NC RO4A 51
Normally open, NO RO4B 52
Common, C RO5C 53
Normally closed, NC RO5A 54
Normally open, NO RO5B 55
115/230 V inputs
Description Marking
115/230 V input 1 HDI7 70
115/230 V input 2 HDI8 71
Neutral point
NEUTRAL
1)
72
115/230 V input 3 HDI9 73
115/230 V input 4 HDI10 74
Neutral point NEUTRAL
1)
75
115/230 V input 5 HDI11 76
115/230 V input 6 HDI12 77
Optional I/O extension modules 267