ABB ACS580-07-0495A-4, Hardware Manual, Page: 56 / 174

52 Guidelines for planning the electrical installation
Additional requirements for ABB motors of types other than M2_, M3_, M4_, HX_
and AM_
Use the selection criteria given for non-ABB motors.
Additional requirements for ABB high-output and IP23 motors
The rated output power of high output motors is higher than what is stated for the particular
frame size in EN 50347 (2001). This table shows the requirements for ABB random-wound
motor series (for example, M3AA, M3AP and M3BP).
Additional requirements for non-ABB high-output and IP23 motors
The rated output power of high output motors is higher than what is stated for the particular
frame size in EN 50347 (2001). The table below shows the requirements for random-
wound and form-wound non-ABB motors with nominal power smaller than 350 kW. For
bigger motors, consult the motor manufacturer.
CMF Common mode filter (E208)
N N-end bearing: insulated motor non-drive end bearing
Nominal AC supply
voltage
Requirement for
Motor insulation
system
ABB du/dt and common mode filters, insulated N-end motor
bearings
100 kW < P
N
< 200 kW P
N
> 200 kW
U
N
< 500 V Standard + N + N + CMF
Nominal AC
supply voltage
Requirement for
Motor insulation system ABB d u /d t filter, insulated N-end bearing and ABB
common mode filter
100 kW < P
N
< 350 kW or
IEC 315 < frame size < IEC 400
U
N
< 420 V Standard: Û
LL
= 1300 V + N + CMF
420 V < U
N
< 500 V Standard: Û
LL
= 1300 V + N + d u /d t + CMF
or
Reinforced:
Û
LL
= 1600 V, 0.2
microsecond rise time
+ N + CMF