ABB ACS 300, User Manual

Page: 56 / 101

42 ACS 300 User’s Manual
Chapter 6 - Control and Parameter Logic
Table 6-1 Control panel keys.
Control Panel
Key
Secondary Key Function
Press to change between Display mode and Setting mode.
Hold down to set the display contrast and:
Press to adjust contrast darker
or
Press to adjust contrast lighter.
Press and hold for three seconds to change between remote control
and local control. Refer to section Panel Operation on page
41 for an
explanation.
Note! Hardware panel lock prevents local control. Message if key is
pressed: “HARDWARE LOCK S1”.
Hold down to select the Local control mode:
Transfers the running data to local control (current speed/direction/
start).
Press to start or stop the drive
or
Press to reset an active fault. (Fault is active when the fault LED is
illuminated.)
Press to set motor rotation direction.
Note! This procedure reverses the motor only when the drive is running
in Local control mode. Refer to section Local on page 41 for additional
information.
Hold down to scroll up in Display and Setting modes.
Hold down to scroll down in Display and Setting modes.