4
ACH550 Installation, Operation and Maintenance Manual
ACH550-UH
1. Prepare for installation
Lifting R1…R6
Lift the drive only by the metal chassis.
Lifting R7…R8
WARNING!
Handle and ship floor mounted enclosures only in the upright position.
These units are not designed to be laid on their backs.
1. Use a pallet truck to move the transport package/enclosure to the installation site.
2. Remove the cabinet side panels for access to the cabinet/pallet mounting bolts.
(6 torx screws hold each cabinet side panel in place. Leave the side panels off until
later.)
3. Remove the 4 bolts that secure the cabinet to the shipping pallet.
WARNING!
Use the lifting lugs/bars at the top of the unit to lift R7/R8 drives.
4. Use a hoist to lift the drive. (Do not place drive in final position until mounting site is
prepared.)
Unpack the drive
1. Unpack the drive.
2. Check for any damage and notify the shipper immediately if damaged components
are found.
3. Check the contents against the order and the shipping label to verify that all parts
have been received.
Tools required
To install the ACH550 you need the following:
• Screwdrivers (as appropriate for the mounting hardware used)
• Wire stripper
• Tape measure
• Drill
• Frame sizes R5…R8 with UL type 12 enclosure: Punch for conduit mounting
holes
• Frame sizes R7/R8: pallet truck and hoist
• For installations involving frame size R6…R8: The appropriate crimping tool for
power cable lugs.
