☛
Q10
SOFTWARE
Q10 CONTROL PANEL
INPUT CONTROLS
INPUT METERS
These meters operate two different ways: If you click Advanced, go to
the Meters section, and choose Pre-Fader, the meters will respond to
the exact dB level of the incoming signal. If you choose Post-Fader in
the Meters section, the meter will measure the level of the incoming
signal, as well as the gain or attenuation applied to the signal with the
channel faders. Because of this, Post-Fader does not accurately
measure your recording volume.
Just above each meter is a numeric display that measures the incoming
signal in dB.
NOTE: To get the best recording quality, record your incoming signals as
loud as you can with out letting them go into the upper red portion of
the meters.
Link
The Link button is used to link the controls of channel 1 to
channel 2, channel 3 to channel 4, channel 5 to channel 6,
and channel 7 to channel 8. This button is used for recording
devices with individual left/right outputs, such as a
synthesizer or drum machine, and is ideal for stereo mics or
mic pairs recording the same source.
You’ll notice that if Link is pressed on channel 1, and you
adjust the channel 1 volume, channel 2 will change as well.
PAGE
2 5
2 5
DIRECT PRO Q10
O W N E R S M A N U A L
