PAGE
2 8
2 8
☛
Monitor
On the far right there are faders labelled MONITOR. This
allows you to boost and cut the main monitor mix. These
faders typically affect the headphone output and the Monitor
L/R outputs. The Monitor fader can affect the other 1/4"
outputs if MONITOR L/R is connected to them the Routing
menu.
The Peak button, if activated, will take note of the highest
volume that has gone through the monitor, measured in dB.
The Reset button will reset the peak volume to zero.
Phantom
If this light is on, it means you have activated Phantom
Power, by pressing the Phantom button on the front of the
Q10
Brightness
This knob allows you to control the brightness of the
appealing Aardvark logo on the front of the Q10. Turn it up
high to show off your Q10, or dim it down, to make the Q10
less noticeable in darker studios.
Source Select
This lets you select what sample rate you want to use the
Q10 at. You can select internal sample rates of 32kHz,
44.1kHz, 48kHz, 88.2 kHz and 96 kHz. Additional options
allow you to slave to Word Clock or S/PDIF. Standard WC is
for slaving to word clock at 48 kHz and lower, WC 96 is for
slaving to word clock at sample rates higher than 48 kHz, and
WC2X is for slaving to word clocks that implement 2X
operation to achieve higher sample rates.
NOTE: If you are recording S/PDIF, you must have Source Select
set to S/PDIF.
Q10
SOFTWARE
Q10 CONTROL PANEL
PLAYBACK CONTROLS
DIRECT PRO Q10
O W N E R S M A N U A L
