How to set up Sonar, versions 2.1 and prior
Go to OPTIONS | AUDIO | ADVANCED (tab)
Put a checkmark in "Always use MME interface", click OK and restart
Sonar.
Return to OPTIONS | AUDIO, and configure in this order:
On the DRIVER PROFILES tab:
· Use the dropdown menu to show the Profile for your Aardvark
product. If you have multiple Aardvark interfaces, you must configure
this section for each.
· There should be no checkmark in "Access Driver in Mono"
· Stream >16 bit data should be set to 32 bit PCM, left-justified
· Set all DMA buffer sizes to 48.
On the GENERAL tab:
· Playback and Record Timing Master should be (depending on what
product you own): 9,10 Direct Pro Q10, 9,10 Aark 24, 5,6 Direct Pro LX6
or 5,6 Direct Pro 24/96
· Aux Bus, Virtual Mains, Sampling rate, Audio Driver and File bit Depth
can be whatever you prefer.
· Under Mixing latency, Buffers in playback Queue can be 2 or 4, the
best setting depends on your specific setup. Lower the buffer size
sliderif you want to reduce latency.
· The wave profiler is not necessary for Aardvark Hardware, and it will
change the settings just made on the DRIVER PROFILES tab, so don't
use it.
Q10
SOFTWARE
CAKEWALK SONAR™ &
SONIC FOUNDRY ACID™/VEGAS™ QUICKSTART
PAGE
4 0
4 0
DIRECT PRO Q10
O W N E R S M A N U A L
