AAON ProFit WV Series, Installation Operation & Maintenance

Page: 12 / 48

12
General Information
AAON WV Series Water-Source Heat Pump
units (WSHP) are designed for indoor
installation only. Units are assembled, wired,
charged and run-tested at the factory.
Certification of Cooling Models
a. Certified as a commercial central air
conditioner with electrically operated
compressors.
b. Certified for indoor installation only.
c. Certified with refrigerant R-410A coils.
Codes and Ordinances
WSHP Series units have been tested and
certified, by ETL, in accordance with UL
Safety Standard 1995/CSA C22.2 No. 236.
System must be sized in accordance with the
American Society of Heating, Refrigeration
and Air Conditioning Engineers Handbook.
Installation of units must conform to the ICC
standards of the International Mechanical
Code, the International Building Code,
Installation of Air Conditioning and
Ventilating Systems Standard, NFPA 90A,
and local building, plumbing and waste water
codes. All appliances must be electrically
grounded in accordance with local codes, or
in the absence of local codes, the current
National Electric Code, ANSI/NFPA 70 or
the current Canadian Electrical Code CSA
C22.1.
Improper installation, adjustment,
alteration, service or maintenance can
cause property damage, personal
injury or loss of life. Startup and
service must be performed by a
Factory Trained Service Technician. A
copy of this IOM must be kept with the
unit.
These units must not be used as a
“construction heater” at anytime
during any phase of construction.
Very low return air temperatures,
harmful vapors, and misplacement of
the filters can damage the unit and its
efficiency.
The Clean Air Act of 1990 bans the
intentional venting of refrigerant as of
July 1, 1992. Approved methods of
recovery, recycling, or reclaiming
must be followed.
Coils and sheet metal surfaces
present sharp edges and care must
be taken when working with
equipment.
CAUTION
WARNING
CAUTION
WARNING