Aanderaa 4117, Operating Manual

Page: 30 / 79

Page 30 Aanderaa Data Instruments AS – TD302
Figure 5-4 System configuration
To enable/disable a parameter:
Select the output parameter from the list, press View/Edit in the lower part of the window, and change the setting
by clicking the box (box is now checked), press Save to save and close the window.
We recommend that you enable all parameters in case of later use. The memory card storage capacity is normally
not a limitation for the SeaGuard. Raw data can be used e.g. to control calibration coefficients and perform quality
control on the data.
The
System Configuration
holds output parameters which can be enabled/disabled by the user, refer
Figure 5-4
Select the property, and press
View/Edit
to set the value. Tap
OK
to return to the
System Configuration
display,
refer
Figure 5-4
. Press Finish to store the settings when complete.
5.3.2
Deployment Settings
The Deployment Settings hold a list of user defined inputs: location , geographic position , vertical position and
reference . To add information to one of these properties, select the property, press View/Edit and with the
keyboard panel enter the text or numbers. Press OK and Finish storing the information.
5.3.3
User maintenance
Node Description, User Information and calibration coefficients are found in User Maintenance
Open Administrative Tools from the Menu button Select User Maintenance and then Pressure Sensor from the
sensor list . Refer
Figure 5-5
. In User Maintenance you find properties that are password protected, and are
set/altered by the ‘advanced user’ , note! the password is: 1000 The properties in user maintenance are therefore
not changed during normal operation. The user maintenance holds three submenus:
•
Node Descriptions
•
Owner
•
Calibration Coefficients