A&D BM-20, Manual

Page: 57 / 100

BM series 55
Calibration report using an external weight
Key operation
1 Press and hold the
CAL
key to display
Cal out
and release the key.
2
Cal 0
is displayed.
3 When updating the calibration mass value, press the
RANGE
key and proceed to step 4.
When using the preset calibration mass value, proceed to step 5.
4 Specify calibration mass value using the following keys.
RANGE
key........The key to select the blinking figure
RE-ZERO
(
+
)key...The key to increase the value of the blinking figure.
MODE
(
-
)key .......The key to decrease the value of the blinking figure.
PRINT
key .........The key to store the new value.
5 When pressing the
RE-ZERO
key, the zero point is measured and the weight value is displayed
for a few seconds.
6 Place the displayed mass on the pan. Press the
PRINT
key to measure the mass and the
weight value is displayed for a few seconds.
7 If GLP output is used,
glp
is displayed and the calibration report is output.
8 The balance returns to weighing mode after this calibration.
Setting
of "
info 1
" Setting of "
info 2
"
AD-8121 printer format General format
Space, ASCII 20h
<TERM> Terminator, CR , LF or CR
CR Carriage return, ASCII 0Dh
LF Line feed, ASCII 0Ah
Manufacturer
Model
Serial number
ID number
Date
Time
Calibration type
Calibration weight
Signature
----------- A - & - D
MODEL ----- BM-300
S/N ----- 01234567
ID ------ LAB-0123
DATE -- 2011/02/20
TIME ---- 12:34:56
CALIBRATED(EXT.)
CAL.WEIGHT
---- +200.0000 -- g
SIGNATURE
-
- - - - - - - - - - - - - -