background image

6

7

1. Safety 

Operation may only be carried out after a instruction and training. 

Maintenance and repair may only be carried out by qualified personnel.

Observe the principles for the safe operation of electrical devices.

For maintenance and repair work, the accompanying documents for the supplier 
components must be observed.

Hazard potential emanating from the AstroPure Air Cleaner.

Electric shock:

Electrical supply line can possibly be defective.

 

Under no circumstances use devices with a damaged electrical connection cable.

 

•  Check the power cords before use. 

•  Damaged cables must be replaced immediately.

•  Electric cables must never be exposed to water, heat or sharp objects.

•  Do not move the device by pulling the power cord.

•  Avoid running equipment and vehicles over power lines, or provide adequate protection 
for them.

•  The device should be in the off mode to connect or disconnect the main power supply.

•  Internal cabling (fan, control panel, UV-C stage) can be defective.

•  Do not continue to operate devices with an internal error and, if possible, disconnect 
them from the power supply.

•  Carry out maintenance and repair work only when the power supply is disconnected and 
the AstroPure air purifier is switched off.

Crushing Hazard:

Due to its own weight, there is a risk of crushing when transporting and moving the 
AstroPure air purifier.

This can result in bruising of the extremities.

The AstroPure air purifier must be moved with an appropriate method to avoid accidental 
injury or damage of any kind. 

Preferred method is to use approved lifting gear and secured against unintentional lowering 
of the load:

1. protect the forklift forks before lifting

2. lift up slighty the AstroPure unit using the forklift and remove it from the wooden pallet

3. put down the AstroPure unit using the forklift

2. Quick Start Guide (Potentiometer Control)

Quick start guide

• 

Observe the safety instructions for safe operation

• 

Ensure a safe stand on smooth, level, stable ground/floor

• 

Lock the castor wheels 

• 

ON / OFF switch in OFF

• 

Set the speed controller to the “OFF” position

• 

Plug in the power plug

• 

ON / OFF switch ON

• 

Check serial number for fan type on the Type Plate on the back of the uni

 

  Serial No.  : E11-2020-12345 => “E”-type   

 

  Serial No.  : Z11-2020-12345 => “Z”-type

• 

Rotate speed setting to desired air volume flow according to the table below

DANGER: ELECTRIC 
SHOCK

DANGER: CRUSHING 
HAZARD

 

There is a risk of crushing when 
opening the maintenance door.
This can result in bruising of the 
extremities. Have device 
maintenance and repair carried 
out by qualified personnel only.

DANGER: CRUSHING 
HAZARD

 

The device can tip over if lifted 
(excessively). This can result in 
bruising of the extremities.
Do not tilt the device.Set up the 
device outside the area of 
movement of people.

DANGER: CRUSHING 
HAZARD

 

Optional: The AstroPure air 
purifier is equipped with an 
additional UV-C stage. UV-C 
radiation bears the risk to cause 
severe damages to the eye and 
skin. The UV-C stage is not 
accessible during normal 
operation.

DANGER: ROTATING 
DEVICE

 

Fast rotating parts of the fan
The high-speed impeller of the 
fan can injure body parts on 
contact. Have device aintenance 
and repair carried out by qualified 
personnel only.

Speed Control 

Set Point

Fan Type

E

Fan Type

Z

0

0

0

1

0

0

2

300

50

3

600

250

4

950

500

5

1250

750

6

1600

1050

7

1900

1350

8

2200

1650

9

2400

2000

10

2400

2300

Yellow warning lights light up:

Filters must be changed by qualified personnel

   

- Note the date of first use
- Note down the operating time
- Observe and document change intervals for filters

   

Have the filter change and maintenance carried out by qualified personnel only

 

In the event of danger or malfunction: 

Pull out the mains plug and have the device serviced by qualified personnel

 

Observe the protective 
instructions on the device. 
Secure the open maintenance 
door against unintentional 
closing.

EAR PROTECTIONS

 

Have device maintenance and 
repair carried out by qualified 
personnel only. Sufficient hearing 
protection must be worn during 
maintenance and repair work 
when the fan is running.

DANGER: NOISE

 

The unencapsulated fan can 
generate sound emissions> 
70dB (A) (with the aintenance 
door open). Damage or loss of 
hearing can result.

Step 1

Step 2

Step 3

Summary of Contents for AstroPure 2000














Reviews: