14
15
Control panel Potentiometer Control
6. Commissioning, Operation, Cleaning and Disposal
Image 5 AstroPure Control Panel
1. Potentiometer Control
2. LCD / PLC Control
The control unit consists of the following individual parts:
Potentiometer Control:
•
ON/OFF switch (11)
•
Operating status light device ON (12)
•
Volume flow controller (13)
•
Status display pre-filter (14)
•
Status display HEPA filter (15)
LCD / PLC
•
ON/OFF switch at the back of
the unit (3)
•
Touch sensitive display (16)
•
Indicators signalling the need for
filter servicing
Filters:
The following filter options are installed:
Type
Style Code
Pre-filter (7)
RedPleat
ISO Coarse 70%
RedPleat
ISO ePM10 70%
RedPleat CF
ISO Coarse 65%
HEPA filter (8) MEGACel I
H14
ASTROCEL III
H14
Initial start-up
The AstroPure air purifiers are delivered ready for use.
Perform the following work steps for initial commissioning:
•
Remove packaging and dispose of properly in accordance with local waste regulations.
•
The AstroPure air purifiers are equipped with four swivel castors for easy
manoeuvrability.
14
•
Make sure that all four swivel castors have good contact with the installation surface
and, if necessary, enable this by repositioning the device.
•
Make sure that the maintenance door of the device is properly closed.
•
Make sure that the air inlet and outlet openings are freely accessible and not obstructed
or occupied.
•
Fix the locking devices of the castors.
General
In case of any abnormal noises, sounds, and vibrations or in case of no operational sounds (no
fan sound), turn the AstroPure Air Cleaner off, disconnect it from the power supply and have
the equipment inspected by trained personnel.
Maintenance work must be carried out by qualified personnel only according to the
instructions by AAF as well as the personnel for the maintenance and repair of
ventilation devices and air filters must be trained and instructed (e.g. according to VDI
6022-4). Personal protective equipment (gloves, respirator, eye protection) must be
worn during maintenance work inside the device and when changing the air filter.
Operation (Potentiometer Control)
• Make sure the ON / OFF switch is in the OFF position.
• Set the volume flow controller / speed controller to a middle position.
• Plug in the power plug.
• Set the ON / OFF switch to ON.
Set the desired volume flow.
• Keep a sufficient distance from the outflow openings.
• The volume flow can be regulated continuously between minimum (25% maximum
volume flow) and maximum volume flow.
• Set the desired volume flow.
• Set the desired volume flow by turning the rotary knob according to set points given in
the table “Quick Start Guide (Potentiometer Control)” (page 7).
CRUSHING HAZARD:
WEAR SAFETY SHOES
