®
Aluminum Athletic Equipment
1000 Enterprise Drive, Royersford, PA 19468
Toll Free: (800) 523-5471 Phone: (610) 825-6565
www.aaesports.com
View from field of Play
Right End Post
(Crimped Loop End)
Inner Post
(Pear Clip Collar Assembly)
Left End Post
(Clamped Loop End)
Clamped Loop End
Detail
Thimble
(must be present)
Cable Clamp Loop
must be on cut
end of cable
After Cable has been fully
tensioned trim cut end and
wrap with electrical tape
Support Cable
Vinyl Jacket
Support Cable
Vinyl Sleeve must
be stripped from
cable loop end
prior to installing
clamps.
Installation Notes:
Refer to collar assembly diagram for
1.
further detail on collar and cable
assembly.
Install Crimped Cable End to Right End
2.
Post collar
using an anchor shackle.
Route cable to Left End Post. Snap cable
3.
into Pear Clips of the Inner Posts along
the way
Before assembling Clamped Cable Loop
4.
End, fully open the turnbuckle.
With anchor shackle and thimble inplace
5.
run cable thru the shackle as shown. Pull
slack out of cable and mark vinyl sleeve
approximately 4" from thimble end. Strip
vinyl from mark location towards cable
loop end.
With the slack still being pulled out of
6.
cable install and secure the cable clamps.
The first clamp should butt upto the
thimble, the second should be spaced
approx. 1" on center from the first. Cable
clamps must be gripping bare cable to
ensure proper seating/grip.
SBS-40
Assembly Instruction
Lower Horizontal
Support Cable
1
1
of 1
2
