®
Aluminum Athletic Equipment
1000 Enterprise Drive, Royersford, PA 19468
Toll Free: (800) 523-5471 Phone: (610) 825-6565
www.aaesports.com
5'-0"
60"
10'-0"
120"
31'-0"
372"
Lower Horizontal
Cable Collar
w/ Anchor
Shackle for
Crimped End
Loop
Lower Vertical
Cable Collar
w/ Tensioner
Assembly
(see collar orientation
detail)
Upper Vertical
Cable Collar
Assembly
(see collar orientation
detail)
Front
View
Debris Ring
(Optional)
If not present
Make sure
lower collars
are positioned
accordingly.
Left
View
Post Cap
pre-installed
Net Pulley
System
40.00°
Collar Orientation
Detail
(Note:
ONLY
vertical cable
collars should be turned
away from netting, this aids
in tensioning the net)
Eyebolt
Detail
3
4
5
Cleat
Detail
10
8
8
6
7
9
9
1
Open
Eyebolt Collar
Detail
Installation Notes:
Lower Collars:
From bottom
1.
of pole slide the lower vertical
cable collar, lower horizontal
collar and and debris ring
(
optional
) into position. To
allow proper insertion into
ground sleeve, lower most
collar should be 60" from end
of post.
Before securing
collars into place make sure
to rotate the lower vertical
collar approx 40°.
(
refer to
diagram
)
Cleat:
Is to be installed so
2.
that it is on backside of post,
opposite net. Screws will be
inserted through cleat and
post and secured on net side
using flat washers, self
locking hex-nuts and cap
nuts. (
refer to diagram
)
Mid Collar:
Note orientation
3.
of collar on post. From top of
pole slide the open eyebolt
collar into position, refer to
dimension provided and
secure into place.
Eyebolt:
Pulley system
4.
comes preassembled to
eyebolt. Install washer onto
eyebolt then insert eyebolt
with washer through front
side of hole at top of post.
From opposite side secure
eyebolt into place using a
flatwasher and Nylock hex-
nut. (
refer to diagram
)
Upper Collar:
From top of
5.
pole slide the upper vertical
cable collar into position
(collar should rest on eyebolt
washers). Before securing
into place make sure to rotate
the collar approx 40°. (
refer
to diagram
)
Make sure warning labels are
6.
present on goal posts.
Note:
Post assembly
should be done
with post laying
down on flat
level surface.
SBS-40
Assembly Instruction
Right End Post
9
of 1
2
