2
6150RFAAA Application Guide
Below is a guide that outlines how to program the wireless keys, RF receiver, and the House ID in the
6150RFAAA for your particular installation.
Are you using
Control Panel
RF keys beyond
system’s capacity?
RF receivers beyond
system’s capacity?
Program
Wireless Keys As
Program RF
Receiver
House ID
Source As
NO
NO
Use Programming Without Local Wireless Keys
YES NO
Local Enable
[1]
System [1]
VISTA-15PCN,
VISTA-20PCN
YES YES
Local Disable
[0]
Local [0]
Installing the 6150RFAAA
Locate the 6150RFAAA in an area and at a height where it is convenient for users to operate the system. The
6150RFAAA must be at least 10' from the control panel to ensure proper operation of the RF receiver.
6150RRF
AAA-002-V0
+
+
+
+
+
+
C
DO
NO
DI
+
_
Figure 1: 6150RFAAA Wiring Connections
WIRING TABLE
Keypad
Control Panel
Wire Color
DI
z
Data
In
Green
Aux Pwr (GND)
Black
+
+ Aux Pwr
Red
DO
x
Data
Out
Yellow
To install the 6150RFAAA, refer to
Figure 1
for wiring connections and perform the following steps:
Step Action
1
Remove the case back by pushing down the 2 snaps along the 6150RFAAA’s bottom edge and pulling
the case apart.
2
Connect the power and data wires from the control panel to the terminals on the 6150RFAAA as
indicated in the wiring table adjacent to Figure 1 above.
3
Reattach the keypad to its case back.
4
Remove the clear protective films from the LCD display.
Note
:
Upon powerup or exit of the Program Mode, the 6150RFAAA alternately flashes "Ad" and the 2-digit keypad
address and the 2-digit receiver address on the display. Press any key to display the system status.
6150RFAAA Programming
The 6150RFAAA is shipped with pre-programmed default values. Below is a chart showing these values. Later
in these instructions are diagrams showing the wireless keys' loops and their default functions. Regardless of
which wireless key you use (even if it is one not shown), loops 1-4 are defaulted for all 8 devices as shown.
These values may be changed to suit the installation.
Entering Program Mode
Press the [1] and [3] keys simultaneously for a few seconds within 30 seconds of applying power or within 30
seconds of removing the case back. The keypad beeps 3 times, and two dashes and two zeroes flash alternately
in the upper left-hand corner of the display. If any other numbers or letters flash in the display, press the [
✱
]
key.
