INTRODUCTION ELRO PRO Keypad Control AP55KE11:
The ELRO PRO Keypad Control AP55KE11 is designed for use with the ELRO 10-ZONE PRO ALARM
SYSTEM AP5500. The PRO Keypad Control is used to Arm, Part-Arm and Disarm the system, or give
a panic alarm, by using a four digit User Access Code.
Transmit Low Battery Code pressed
Indicator LED Indicator LED Confirmation LED
Arm
Disarm
PARM1
PARM2
Installing and Configuring (put in Housecode) of the PRO Keypad Control:
First step is to put your Alarm Panel in the Installation modus.
Press , ? ? ? ? (???? standard
Master Password), display show 1.USER SETUP.
Remove the fixing screw from the bottom edge of the PRO Keypad Control, and remove the mounting
plate. Use the mounting plate to mark the holes to drill. Fix the mounting plate with provided wall plugs
and screws.
Check if system jumper like on figure. In order to prevent unauthorised use you must configure your
PRO Keypad Control. Because of security reasons this is not done by eight DIP switches like on the
figure above. To configure the house code first check your house code of the Alarm Panel and other
sensors. If the house is like above: 1-ON, 2-ON, 3-OFF, 4-ON, 5-OFF, 6-OFF, 7-OFF and 8-ON. We
configure the code (of all the ON-positions) as the house code for the PRO Keypad Control: 1-2-4-8.
Now press on the PRO Keypad Control, followed by 1 2 3 4 (this is the standard code of the
PRO Keypad Control!) and again; the will illuminate and flash twice. Press now your house
code, followed by the will illuminate and flashes three times to confirm the setting.
Next IMPORTANT step is to change the User Access Code:
Press, followed by the standard code 1234 and , the will illuminate once and flash
twice. Enter now your NEW Access Code : ? ? ? ? and the will illuminate once and flash
three times, to confirm setting. Change now the Installation modus of the Alarm Panel to Disarm
Ready modus, by pressing
