PAGE 12
I
NSTRUCTION MANUAL
AAPRODUCTS INC.
F
or Technical Support Call:1-888-806-3972
/
626-332-4245
S
TEP 1
Use the proper tool, take off the cover on the roof top to locate the M8 threaded hole. Place a Rubber Seal for
each hole. Installing the Base Bracket: Put two Carriage Bolts M8*30 on the Base Bracket upside down. Align the
middle hole to the vehicle
’ s M8 threaded hole.
( See FIG 14 )
S
TEP 2
Set position for the Adapter Base: Two of the upside down bolts should also goes through the Adapter Base.
Connecting the Mounting Bases with the Adapters. Set the Bolt M8*45 on the Mounting Base
’ s middle hole, align all
three holes then connect the Mounting Bases and Adapter Kit together, tighten the Bolt M8*45 to secure the rack with
the vehicle. Tighten the other two Carriage Bolts M8*30 on the Adapter with Nuts & Washers M8.
( See FIG 15-1 & 15-2 )
After installing the rack set, adjust all the Cross-Bars to align with each other and tighten all fasteners. Insert the
Rubber Sealing Strip into the Cross-Bar’
s upper & lower channel to reduce wind-noise. Cut the right length as needed.(
See FIG 15-3 ).
Carriage Bolt M8 * 30
FIG 15-1
FIG 15-3
Insert the Rubber Sealing Strip into the
Cross-Bar’s
Upper & Lower Channel
to reduce
wind-noise. Cut the right length as needed.
Bolt M8 *45
&
Spring Washer M8
&
Washer M8
FIG 15 -2
FIG 14
M8 Threaded Hole
Optional: Place a Rubber
Seal for each hole.
Nut
&
Washer M8
FORD TRANSIT CARGO