9
CHAPTER 2 INSTALLATION
2-1 INSTALLATION PROCEDURE
Before installing the computer, please prepare all components such as CPU, DRAM;
peripherals such as hard drive, keyboard, CD-ROM disk drive and accessories such as
cables. Then, install the system as following:
1. Plug CPU/ heat sink (refer to Pentium II installation guide,
Appendix A
), and
DRAM modules on the mainboard.
2. Set DIP switch based on your configuration.
3. Plug add-on cards into PCI/ISA slots, if needed.
4. Connect cables to peripherals, specially for VGA and Sound connector.
5. Make sure all components and devices are well connected, turn on the power and
setup System BIOS based on your configuration.
6. Install peripherals, add-on card drivers and test them.
7. If all of above procedures are success, turn-off the power then plug all of them into
your computer case.
Remark :
Before you do the mainboard installation, please keep in mind that VGA
and Sound chipsets are built-in on the ATC-6510 mainboard along with
MicroATX Form Factor.
