A to Z Rubber Stamps RAPIDPRINT A Series, Manual

Page: 36 / 122

Retaining Pawl Springs:
- Use a hooked tool ( as shown in figure 19 ) to first remove end of spring attached to the
threaded shaft, then remove the end attached to the retaining pawl.
NOTE:
SPRINGS ARE COLOR CODED. BE SURE TO REINSTALL EACH SPRING IN ITS CORRECT
LOCATION (SEE TABLE l).
Retaining Pawl And Retaining Pawl Shaft:
- Remove one of two "E" rings securing the shaft.
-Tap shaft so it protrudes from one side of frame. Turn shaft as you pull it outward,
allowing pawls to drop.
Wheels And Swing Assembly:
NOTE:
TO ALLOW REMOVAL OF WHEELS AND SWING AS ONE UNIT, IT IS BEST TO USE A
"FLOATING SHAFT". THIS IS MADE BY CUTTING AN OLD WHEEL SHAFT TO EXACT OUTSIDE
DIMENSIONS OF SWING.
-Loosen wheel shaft locking screw and disengage retainer.
-Use "floating shaft" to push out existing shaft, allowing swing to fall free of frame. (Push
from side of frame opposite retainer
figure 20 ).
01/04/2012 36