A to Z Rubber Stamps RAPIDPRINT A Series, Manual

Page: 99 / 122

VISUAL COUNTER
RETROFITTING A STANDARD AN-E/AR-E MACHINE
-Replace Bottom Front Plate with p/n 00-07240-000000 (or machine a 1.435 x .885 cutout in
existing plate).
-Remove Retaining Clip from Counter p/n 00-02855-000001.
-Guide counter leads through opening of Bottom Front Plate from the front of machine.
-Reinstall Retaining Clip.
-Once in place, fasten Counter by pushing down on Retaining Clip until firmly locked into
position.
WIRING AN-E MACHINE
Wire an AN-E machine per wiring diagram 08-00218-000030 and/or perform the following
steps:
1-Replace P.C. Bd with p/n 01-07310-000002.
2-Tap one counter lead to white wire attached to position 5 of connector and the other
lead to white wire attached to position 12 of connector. This can be done by using
a self-stripping splice connector p/n 00-05491-000001 (2 required).
WIRING AR-E MACHINE
Wire an AR-E machine per wiring diagram 08-00217-000008 and/or perform the following
steps:
1-Replace P.C. Bd with p/n 01-07310-000002.
2-Change connections of white motor leads from positions 5 & 12 to 4 & 13.
3-Insert counter leads in connector positions 5 & 12.
01/04/2012 99