A to Z Rubber Stamps RAPIDPRINT A Series, Manual

Page: 106 / 122

ELECTRIC SECURITY LOCK
RETROFITTING A STANDARD AN-E /AR-E MACHINE
-Prepare Switchlock p/n 2865-573 by soldering two Blue Wire Assemblies p/n 1-6930-11 to
Switchlock terminals 1 & 3.
-Drill 3/4"Dia. hole. Pre-drilling a 5/16" dia. pilot hole is recommended.
-Insert Switchlock through hole and fasten it into place with the supplied hex nut.
NOTE: key slot must be in OFF position when vertical (counterclockwise).
WIRING AN-E MACHINE
Wire machine per wiring diagram 08-218-2 and/or perform the following steps:
1-P.C. Bd must be D revision or later. If not, it must be replaced with p/n 1-7310-
1129.
2-Remove yellow wire from position 9 of connector and reinsert it into position 8.
3-Insert blue wires from Switchlock into connector positions 9 & 10.
WIRING AR-E MACHINE
Wire machine per wire diagram 08-217-18 and/or perform the following steps:
1-Remove yellow wire from position 7 of connector and reinsert it into position 8.
2-Insert blue wires from Switchlock into connector positions 6 & 7.
CASTING MODIFICATION FOR
ELECTRIC SECURITY LOCK FEATURE
01/04/2012 106