A.M.I Italia Saver One P, User Manual

Page: 38 / 81

38
7.2 ACTIVATION
TEST
The Saver One P performs functional tests only if the battery is installed.
Each time a battery is inserted, the device will perform a diagnostic ACTIVATION test.
During this test the device performs a complete check (firmware/hardware), which involves battery use equal to a
shock; therefore, it is advisable, once performed, not to remove the battery from the device.
The ACTIVATION test requires action by the operator, who must perform the following operations:
❖
Insert the battery in the device
If the battery is correctly inserted, the Saver One P will automatically turn on emitting an acoustic signal and the
power button will light up green while the control LED will turn off.
The following screens will appear on the colour TFT display:
The device will issue a voice prompt (audio): “Device test”
“Push the blinking red button”
The shock button will start blinking.
The operator will have a maximum of 60 seconds
* to push the shock button.
❖
Push the shock button to launch the ACTIVATION test
If the shock button is pressed correctly, it will stop blinking and the device will start the activation test.
The following screens will appear on the colour TFT display:
❖
Switch off the device
If it does not need to be used immediately, switch off the Saver One P and leave the battery inserted to ensure
periodic self-testing (see Paragraph 7.3)
*
If the shock button is not pressed within the time limit indicated by the countdown, the Saver One P detects an error.
Switch the device back on and press the shock button within the time limit indicated by the countdown.
If, on the other hand, the shock button has been pressed but the shock button continues blinking it means that the shock button
does not work properly. Turn off the device and perform the operation again; if the problem persists, contact the authorized
technical support centre.