![background image](http://html.mh-extra.com/html/a-j-antunes/utx-200/utx-200_manual_447216013.webp)
UNIVERSAL TOASTER UTX-200
13
P/N 1010904 Rev. 14 04/06
McDonald’s
Daily Cleaning
NOTE: Do NOT wash accessories in the Power
Soak machine.
1. Turn the Rocker Switch (power On/Off) to OFF
(Figure 5). The red light on the switch will turn off.
2. The fans will continue to run with the display
reading
Cleaning Mode
. The Cleaning Mode
will continue for 45 minutes and completely shut
the unit down automatically when complete.
3. Using Heat Resistant Gloves, r
emove the following
items from the unit (refer to Figure 1):
• Bun Buffer (front of unit)
• Bun Feeder (top of unit)
• Breakfast Feeder (rear of unit)
• Release Sheet and Retainer Bar (top of unit)
• Unit Crumb Tray (rear of unit)
4. Wash the items listed above in hot, soapy water,
rinse in clean water, and allow to air dry. Then
wipe these parts with a clean cloth dampened
with Sanitizer and allow to air dry.
5. Remove the Release Sheet from the Release
Sheet Retainer Bar (Figure 1).
6. Lay the Release Sheet on a clean, flat, dry sur-
face. Spray
EXCEED Glass and Multi-purpose
Cleaner (HCS)
on a clean, dry towel.
7. Wipe the towel firmly across the Release Sheet
from top to bottom over its entire surface. Repeat
this procedure with a clean, dry towel dampened
with water.
8. Next, wipe the Release Sheet with a clean towel
dampened with
KAYQUAT II™ Sanitizer (HCS)
solution and allow to air dry. Repeat Steps 6
through 8 on the reverse side of the Release
Sheet.
MAINTENANCE
WARNING
The unit will remain hot to the touch while it is
cooling down. Personal injury and burns may
result from touching the unit before it is finished
cooling down.
Figure 16. Back Panel Release Latches
SELEC
T
SELECT
LOCKED
UNLOCKED
Release Latches (on
BOTH sides of the rear of
the unit) are locked when
in the horizontal position.
Turn both latches to the
vertical position to open
and unlock the Back
Panel
Figure 15. Master Links
Two Master Links
with extra holes
9. Turn the two Back Panel Release Latches so they
are in the vertical position and open the Back
Panel (Figure 16).
10. Apply
McD© All-Purpose Super Concentrate
(APSC) (HCS)
on a
non-scratch pad
and clean
the metal Conveyor Belt for two complete revolu-
tions. Use the dual holes in the master links as a
reference (Figure 15).