![background image](http://html.mh-extra.com/html/a-j-antunes/utx-200/utx-200_manual_447216014.webp)
UNIVERSAL TOASTER UTX-200
14
P/N 1010904 Rev. 14 04/06
McDonald’s
11. Rinse/wipe the Conveyor Belt
with the grain
(side to side) using
KAYQUAT II™ Sanitizer
(HCS)
solution and allow to air dry.
NOTE: Refer to the cleaning label located on the
back of the unit.
NOTE: If the Conveyor Belt appears yellow/brown,
repeat Steps 8 and 9 until the build up is removed.
The belt should be silver/metallic when cleaned
properly. If build up does not come off, use oven
cleaner.
NOTE: If necessary, press and hold both MUFFIN/
BAGEL selector buttons on the back of the
unit (Figure 5) to advance the belt for exposing
uncleaned belt.
10. Wipe the entire exterior surface of the toaster with
a clean, dry towel, dampened with
KAYQUAT II™
Sanitizer (HCS)
and allow it to air dry.
NOTE: Be sure to wipe the bun drop area clean as
well!
11. Insert the Release Sheet Retainer Bar into the
top of the Release Sheet.
12. Hang the Release Sheet Retainer Bar and
Release Sheet onto the top of the unit.
NOTE: The Release Sheet must be inserted between
the Platen and the two Side Brackets of the unit
so it will not be pinched by the Platen Conveyor
(Figure 2).
13. Reassemble all accessories onto the unit accord-
ing to Figure 2.
14. Verify that the Bun Thickness Compression
Control knob is set to 3 (Figure 13).
15. Close the Back Panel and lock the Back Panel
Release Latches (Figure 16).
MAINTENANCE (continued)