![background image](http://html.mh-extra.com/html/a-j-antunes/utx-200/utx-200_manual_447216007.webp)
UNIVERSAL TOASTER UTX-200
7
P/N 1010904 Rev. 14 04/06
McDonald’s
Operating Instructions
The Universal Toaster has three operational modes:
Bagel, Muffin, and Lunch Modes.
Follow these steps to start the Universal Toaster:
1. Turn the Rocker Switch (power On/Off) to On.
The unit will click three times. This is normal.
There will be a 20 second countdown as the unit
sets defaults.
2. The unit starts up in Breakfast mode. The display
reads
Muffin Wait
(Figure 3) and automatically
displays the
Muffin Ready
message when the
unit reaches proper operating temperature for
Breakfast operations (approximately. 20 minutes)
(Figure 4).
NOTE: Each time the Power is turned on, the unit
initially starts a 20 minute Muffin Wait cycle.
OPERATION
3. To change from Muffin Mode to Bagel Mode, use
one of the
MUFFIN/BAGEL
selector buttons.
These buttons are located on the back of the unit
on both side housings (Figure 5). Selection can
be made from either side.
NOTE: You only need to press one MUFFIN/BAGEL
selector buttons to switch Muffin or Bagel mode.
Muffin Wait
PRGM
MOTOR
PLTN
UT
I/R
NEXT
PREV
SELECT
BREAKFAST/LUNCH
ADJUST
Muffin Ready
PRGM
MOTOR
PLTN
UT
I/R
NEXT
PREV
SELECT
BREAKFAST/LUNCH
ADJUST
Figure 3. Muffin Wait Display
Figure 4. Breakfast Ready Display
Breakfast to Lunch Change-over
Follow these steps to change the Universal Toaster’s
operation from Breakfast mode to Lunch mode:
NOTE: During Lunch operation, the Bun Thickness
Compression Control knob should be set to 3 for
best toasting quality.
1. 15 to 30 minutes before change over time, press
the UT button which is located in the access hole
on the front cover (Figure 6).
SELECT
SELECT
UT
Muffin Ready
Location of the UT
Button
Figure 6. UT Button Location.
Figure 5. MUFFIN/BAGEL Selector Buttons
MUFFIN/BAGEL
Selector Buttons (on
both sides of rear of
unit).
Power On/Off
NOTE: If the toasting quality needs to be adjusted,
refer to the section titled “Adjusting Toasting
Quality” in the Operation section of this manual.