![background image](http://html1.mh-extra.com/html/a-j-antunes/ctx-200l/ctx-200l_equipment-manual_3138768007.webp)
Club ToasTer CTX-200l
7
P/N 1011038 06/09
McDonald’s
operating Instructions
Follow these steps to start the Club Toaster:
1. Turn on the Power Switch located at the back of
the unit. There will be a 20-second countdown as
the unit sets defaults.
2. The unit will start to warm up and will show the
Wait
message in the display (Figure 3).
Note: the Control Panel and display are located
on the back of the unit.
3. When the unit reaches operating temperature, the
display will read
Ready
(Figure 4).
4. The unit is ready for operation.
oPeratIoN
Note: If the toasting quality needs to be adjusted,
refer to the section titled “adjusting toasting
Quality” in the operation section of this manual.
MOTOR
PLTN
CT
PLTN
Wait
PRGM
NEXT
PREV
SELECT
ADJUST
BELTS
STOP/START
figure 3. Club toaster Wait display
figure 4. Club toaster ready display
Ready
MOTOR
PLTN
CT
PLTN
PRGM
NEXT
PREV
SELECT
ADJUST
BELTS
STOP/START
figure 5. CtX-200l toasting route
Club Inside
Bun Feeder
Bun Buffer
Large Black Arrows
Indicate Club
Route Through
toaster
toasting Clubs
Follow these steps to toast clubs with the Club Toaster:
1. Make sure the unit is turned on and that the
display reads
Ready
.
2. Insert the club into Bun Feeder (Figure 5).
3. The club will emerge from the toaster into the Bun
Buffer.
adjusting toasting Quality
The toasting quality of the CTX-200L can be adjusted
to provide a lighter or more darker toasted product.
Follow these steps to adjust toasting quality.
1. At the back Control Panel, press and release the
adjust
button (Figure 6).
2. Use the
PreV
and
NeXt
buttons to adjust the
toasting quality to lighter or darker respectively
(Figure 6).
Note: Pressing the PreV button decreases toast-
ing darkness. Pressing the NeXt button increases
toasting darkness.
3. Test several clubs to verify that the product is
toasting at the desired quality.
4. If the toasting quality needs further adjustment,
repeat Steps 1 through 3 as necessary.
Note: this setting is maintained when the unit is
powered off.
Note: the adjustment range is +/- 10% of cycle
time. therefore, each adjustment represents a 1%
change toward the desired result.
Note: two bars on the display indicate the adjust-
ment is in the center position.