![background image](http://html1.mh-extra.com/html/a-j-antunes/ctx-200l/ctx-200l_equipment-manual_3138768014.webp)
Club ToasTer CTX-200l
14
P/N 1011038 06/09
McDonald’s
Problem
Possible Cause
Corrective action
No display.
No light on Power Switch.
Unit not plugged in.
Plug the power cord into the appro-
priate outlet.
hi-Limit thermostats are tripped.
Reset hi-Limit thermostats.
Circuit Breaker tripped.
Reset Circuit Breaker.
Power Cord and/or plug are
damaged.
Contact your maintenance person
or Authorized Service Agency.
Inoperable Power Switch.
Belt wraps stop turning, but conveyor
chain continues to turn.
Underside of Belt and Conveyor
Chain have excessive buildup.
Clean Belt Wrap as described in
the Maintenance section of this
manual.
Product is getting stuck inside the
toaster.
Belt Wraps are dirty, worn, or need
replacement.
Inspect the Belt Wraps. Replace
or clean according to the
Maintenance section of this
manual.
Unit displays the following message:
Conveyor Motor Fault
Product is getting stuck in the
conveyor system or the conveyor
system is jammed.
Refer to the Operation and
Maintenance sections of this man-
ual for proper compression settings
and cleaning procedures.
The motor controller circuit has failed
or is inoperable.
Call your Authorized Service
Agency for service.
Unit displays the following message:
SSR Failure - System Stopped
A relay has failed, preventing proper
heater control.
The toaster cannot be operated
with his kind of failure. Contact
your Authorized Service Agency for
service.
Unit displays the following message:
Platen Fault
A heater or relay in the Platen circuit
has failed.
Contact your Authorized Service
Agency for service.
troublesHootING
CautIoN
to avoid possible personal injury and/or damage to the unit, all inspections, tests, and repair of electrical
equipment should be performed by QualIfIed serVICe PersoNNel. the unit Must be completely shut
down and unplugged before servicing, except when electrical tests are required. use extreme care during
electrical circuit tests. live circuits will be exposed.