15000-MNL-01 Rev A
18
Connecting the AC-DC Power Supply and AC Power Cord
Insert the external power supply cord receptacle into the DC jack on the rear of the LDI (Figure 13). Insert
the AC power cord plug receptacle end into the AC plug on the external power supply. Plug the AC power
cord into a standard AC outlet. See the technical specifications in this manual for power requirements.
Only the power cord supplied with the unit should be used. The use of an
inadequately rated power cord may impair safe operation of the equipment.
Figure 13. Power connection on the LDI rear panel.
Setting Up Control Interfaces
Run
“
LDI Setup.exe
” supplied on the USB flash drive
to install the LDI graphical user interface ("LDI.exe")
and device drivers on the host PC. Follow the prompts to complete the installation. Note: The device
drivers will install after the LDI.exe application install completes.
If external signals will be used for controlling intensities and/or shutters, connect the control cable to the
DB25 system connector on the LDI rear panel (Figure 14).
Connect the USB port to the host PC with the cable provided (Figure 14).
