Hacousto Holland bv
Industrieweg 87
2651BC Berkel & Rodenrijs
4EVAC Compact 500 quick guide
DoP OD 16.47
Author:
DD
Design revision:
2.0
Page 4 of 33
3.
Where do I start?
First, make sure that you are officially allowed to access the Compact 500 hardware. This is usually the case
if:
you are an authorized representative of 4EVAC;
you have been trained by 4EVAC or its authorized representative for installation, service and
commissioning of the Compact 500 Voice Evacuation System.
Unauthorized hardware and/or software modifications are against the law and outside of manufacturer’s
responsibility. If you have doubts about your status and access level permissions, please contact the 4EVAC
main office.
Important note: Access level explanation
Opening the Compact 500 front door gives physical access to all
interfaces, internal system connections and sensitive hardware settings
that are of high importance to system operation mode, hardware
reliability and safety (Access Level 3 according to EN54-16, Annex A).
This access level (and higher) is strictly protected by the manufacturer
and reserved only for service personnel which is trained, approved and
officially certified by the manufacturer. Any actions carried out in
Access Level 3 without the manufacturer’s explicit approval may lead
to incorrect settings or hardware damage, causing serious system
malfunction, and therefore are strictly prohibited and void
manufacturer’s warranty.
4.
Unboxing 4EVAC Compact 500
The original shipping package includes a bottom foam protector that allows you to place the main unit in
vertical position on the floor after unboxing.
Caution! Never put Compact 500 in a vertical position directly on the floor, table or any other hard
horizontal surface. Doing this may deform or break bottom parts of the housing.
Optionally, the cabinet may be temporarily placed on its back, on a flat horizontal surface.
To safely unbox the Compact 500 main unit, follow these steps:
1.
Carefully cut the two strapping tapes and remove them.
Caution! Strapping tapes may be under very high tension!
2.
Carefully put the package upside-down.
3.
Open the bottom side and unfold the bottom panels of the package so that the bottom foam
protector is free from obstacles.
4.
Carefully flip the package, first on its side and then right-side up.
5.
Pull the carton package upwards and remove it.
6.
Fold the protective foil down or remove it, leaving the Compact 500 main unit resting in the foam
protector until you’re ready to hang it on the wall.