User Manual
| VISIX PTZ Network Camera
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
32
3)
Click
to save the above settings
.
NOTE:
!
If the DHCP server is available, you can check
to automatically obtain an IP
address and other network settings from that server.
!
The valid value range of Maximum Transmission Unit(MTU) is 500 ~ 9676. The default
value is 1500.
!
The Multicast sends a stream to the multicast group address and allows multiple clients
to acquire the stream at the same time by requesting a copy from the multicast group
address.
Before utilizing this function, you have to enable the Multicast function of your router
and configure the gateway of the network speed dome.
!
If the DNS server settings are required for some applications (e.g., sending email), you
should properly configure the
Preferred DNS Server
and
Alternate DNS server
.
Figure 6-‐8
DNS Server Settings
NOTE:
The router must support the route advertisement function if you select
Route
Advertisement
as the IPv6 mode.
CONFIGURING PORT SETTINGS
Purpose:
If there is a router and you want to access the speed dome through Wide Area Network (WAN), you
need to forward the 3 ports for the speed dome.
Steps:
1)
Enter the Port Settings interface:
Configuration > Basic Configuration >
Network > Port
Or
Configuration > Advanced Configuration >
Network > Port
Figure 6-‐9
Port Settings
2)
Set the HTTP port, RTSP port and port of the speed dome.
HTTP Port
: The default port number is 80.
RTSP Port
: The default port number is 554.
HTTPS Port
: The default port number is 443.