User Manual|
VISIX Network Camera
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
39
With the function enabled, you don’t need to configure the port mapping for each port, and the camera is
connected to the Wide Area Network via the router.
Steps:
1)
Enter the UPnP™ settings interface.
Configuration >Advanced Configuration >
Network > UPnP
2)
Check the checkbox to enable the UPnP™ function.
The name of the device when detected online can be edited.
Figure 6-‐17
Configure UPnP Settings
EMAIL SENDING TRIGGERED BY ALARM
Purpose:
The system can be configured to send an Email notification to all designated receivers if an alarm event is
detected, e.g., motion detection event, video loss, video tampering, etc.
Before you start:
Please configure the DNS Server settings under
Basic Configuration >
Network > TCP/IP
or
Advanced
Configuration >
Network > TCP/IP
before using the Email function.
Steps:
1)
Enter the
TCP/IP Settings
(
Configuration > Basic Configuration >
Network > TCP/IP
or
Configuration
> Advanced Configuration >
Network > TCP/IP)
to set the IPv4 Address, IPv4 Subnet Mask, IPv4
Default Gateway and the Preferred DNS Server.
Note:
Please refer to
Section 6.3.1
Configuring TCP/IP Settings
for detailed information.
2)
Enter the Email Settings interface:
Configuration > Advanced Configuration > Network > Email