3M Peltor Optime I, Manual

Page: 7 / 68

6
CLEANING INSTRUCTIONS
1. At the end of each shift the cushions of the ear muffs should
be wiped with a suitable material, for example 3M™ 105 Face
Seal Cleaners, so they remain clean and hygienic. The product
can also be cleaned using mild detergent and water.
2. If the ear muffs cannot be cleaned or are damaged, dispose
of the product and obtain a new pair.
3. Cushions and inserts can be replaced using the following
Hygiene Kits as shown below.
Remove the cushions and inserts as shown.
See Figure 10.
Replace the worn or damaged cushions and insert with the new
pair from the appropriate hygiene kit.
4. Replace the product within 5 years from the date of
manufacture or immediately if damaged.
NOTE
In addition to the hygiene kit shown, 3M™ Peltor™ HY100
sweat pads are also available that can be applied onto the ear
muff cushions to help absorb sweat and moisture for improved
comfort and hygiene.
STORAGE AND TRANSPORTATION
Follow the manufacturers recommendation for storage.
Check packaging for further information.
{
Date of Manufacture
\
Temperature Range
}
Maximum Relative Humidity
Always store the product in the original packaging and away
from any sources of direct heat or sunlight.
When stored ensure the headband is not stretched (applies to
headband/neckband versions) and the cushions are not
compressed as this may damage the product.
APPROVALS
These products meet the requirements of the European
Community Directive 89/686/EEC (Personal Protective
Equipment Directive) and are thus CE marked.
Certi
¿
cation under Article 10, EC Type-Examination, has been
issued for these products by
INSPEC International Limited, 56 Leslie Hough Way, Salford,
Greater Manchester M6 6AJ, UK (Noti
¿
ed Body number 0194)
and Finnish Institute of Occupational Health (FIOH),
Topeliuksenkatu 41aA, FIN-00250 Helsinki, Finland (Noti
¿
ed
Body number 0403).
3M™, Peltor™, Optime™ and Bull's Eye™ are trademarks of
3M Company.
MATERIAL LISTING
Headband/Neckband
Helmet Attachment Arm
Cups
Inserts
Cushions
Cushion Covers
Stainless Steel wire, PVC, Acetal
ABS
Polyether
Polyether
Polyether and Glycerine
(H510 and H520 only)
PVC
Stainless Steel wire, Acetal, Polyamide
ABS
Polyether
Polyether
Polyether and Glycerine
(H31 only)
PVC
Headband Version Headband/Neckband/Foldable Version Helmet Mounted Version
Mass (g)
H510A = 180
H520A = 210 H540A = 285
H31A = 190 H510B = 165 H520B = 195
H540B = 270 H510F = 200 H520F = 230
H31P3 = 285 H510P3E = 205 H520P3E = 235
H540P3E = 310
HY51
HY52
HY54
HY52GN
HY54GN
Hygiene Kit Model Ear Muff Model
3M™ Peltor™ H510 Series Optime™ I
3M™ Peltor™ H520 Series Optime™ II
3M™ Peltor™ H540 Series Optime™ III
3M™ Peltor™ H520 Series Bull's Eye™ II
3M™ Peltor™ H540 Series Bull's Eye™ III
HYGIENE KITS