3M Matic 7000a, Instructions And Parts List

Page: 37 / 170

11 - SET UP AND ADJUSTMENTS
(continued)
25
2014 June
Note:
Loosen
but do not
Remove
Column
Screws
7000a-7000a3 Pro - NA
A
B
Figure 11-5
Figure 11-6
Figure 11-4
Figure 11-7
B
11.5 Special Set-Up Procedure for Outer Column Re-Positioning
(continued on next page)
Moving the outer columns will increase/decrease the maximum box height capacity of the
7000a-7000a3 Pro
case sealer.
1. Place solid blocks approximately 305mm high at the front and rear of the upper taping head assembly as
shown in
Figure 11-7A
.
2. Crank the upper taping head assembly down until it touches these blocks.
3. Loosen (but do not remove) the four (4) screws and washers that fasten each column to the frame
(Figure 11-7B).
Note:
You may also need to loosen the two set screws in the nut plate bracket (located above bottom two column screws).
4. Turn the height adjustment crank clockwise to raise the outer columns until they reach the stop.
Note:
Instructions are indicated for the Standard Column Position (Also see speci fi cations). If Alternate Column
positions are needed, loosen and re-position the column stop.
5. Tighten the eight (8) screws and washers in each column. Also tighten two Set Screws (if applicable)
Crank upper taping head assembly up and remove blocks.
A