3M Matic 7000a, Instructions And Parts List

Page: 31 / 170

19
Crank
Assembly
Fig. 7-7A
Compression
Rollers
Fig. 7-7C
7-INSTALLATION
(continued)
2014 June
7000a-7000a3 Pro - NA
7.5 Removal of Plastic TIes
Cut the plastic which attaches the top head to the
frame and remove the polystyrene blocks
(Figure 7-4).
Cut the plastic strap which attaches the strip and the
EMERGENCY STOP cable to the frame
(Figure 7-5).
Cut the plastic ties holding the lower taping head in
position
(Figure 7-6).
7.6 Assembly Completion
1. Crank - Install the crank handle on top of
the left column as shown
(Figure 7-7A).
Upper taping head frame height adjustment
crank is installed on the side of the left column.
If desired, for operator convenience, the crank
may be moved to the alternate position on the
right side of the machine.
2. Tape Drum Bracket - Install the upper tape
drum bracket on the top cross bar as shown
(Figure 7-7B).
3. Compression Rollers - For shipping purposes,
the Compression Rollers are packaged upside
down. Flip Rollers over and mount using
provided
hardware
(Figure 7-7C).
4. Centering Guides - The Box Centering
Knobs are located in the Tool Kit Box.
Install Knobs on Centering Guides
(Figure 7-7D).
Figure 7-5
Figure 7-7
Figure 7-6
Figure 7-4
Upper Tape
Drum Bracket
Fig. 7-7B
Centering
Guide
Knobs
Fig. 7-7D
B
D
A
C