3M Matic 7000a, Instructions And Parts List

Page: 30 / 170

18
Figure 7-2
7-INSTALLATION
2014 June
7000a-7000a3 Pro - NA
Figure 7-1
7.4 Machine Set-Up / Bed Height
A tool kit containing some tools are supplied
with the machine. These tools should be
adequate to set-up the machine, however,
other tools supplied by the customer will be
required for machine maintenance.
7.3 Tool Kit Supplied with the Machine
7.1 Operating Conditions
The machine should operate in a dry and relatively
clean environment (See Speci
fi cations).
7.2 Space Requirements for Machine Operation
and Maintenance Work
Minimum distance from wall
(Figure 7-1)
:
A = 1000mm.
B = 700mm.
Minimum height = 2700mm.
•
To reduce the risk associated with
mechanical and electrical hazards:
− Allow only properly trained and
quali fi ed personnel to operate and
service this equipment.
•
To reduce the risk associated with
muscle strain:
− Use the appropriate rigging and
material handling equipment when
lifting or repositioning this equipment.
− Use proper body mechanics when
removing or installing taping heads
that are moderately heavy or may be
considered awkward to lift.
WARNING
WARNING
B
A
1 - Lift the machine with belts or ropes paying attention
to place the belts in the points (
Figure 7-2).
To set the machine bed height, do the following:
2 - Adjust machine bed
height. The case
sealer is equipped
with four (4) adjust-
able legs that are
located at the cor-
ners of the machine
frame.
The legs can be
adjusted to obtain
different machine
bed heights
(Figure 7-3)
.
Also refer to the
"Speci
fi cations" section.
3 - Lock the screws.
4 - Repeat the operation
for all legs.
(It is not necessary
to fi x or anchor the
machine to the fl oor).
5 - For Outer Column Repositioning -
See Special Set-up Procedure
(Section 11).
Figure 7-3