3M 3M-Matic Dual S-867 II, Instructions And Parts List

Page: 35 / 62

15
Tape Loading and Threading – The tape drum assembly is set up for dispensing 3/8 inch [9 mm] or 1/2 inch
[12 mm] wide tape. For dispensing other tape widths refer to "Adjustments – Tape Width." A tape threading diagram
is located outside the applicator on the top of the nest for quick reference.
Operation
•
To reduce the risk associated with mechanical and pneumatic hazards:
−
Read, understand and follow all safety and operating instructions before operating or servicing the case
sealer
−
Allow only properly trained and qualified personnel to operate and/or service this equipment
WARNING
For easy access to tape loading and threading, open
the cover located on the right side of the S-867.
Release the cover latch, shown in Figure 2-1, pull
outward on the upper part of the latch, unhook the
latch and pivot open the cover. Refer to Figure 4-1 and thread the tape as follows:
1. Place the tape roll on the tape drum so the tape
is dispensed downward, adhesive side forward.
The tape roll must be fully against the drum
flange.
2. Pull approximately 12 inches [300 mm] of tape
from the roll and thread the tape under the
tension roller, adhesive side up.
•
To reduce the risk associated with mechanical and pneumatic hazards:
−
Never attempt to defeat the machine guard interlock
•
To reduce the risk associated with pinch and entanglement hazards:
−
Turn air supply off and disconnect before performing any adjustments, maintenance or servicing the machine
or taping heads
WARNING
Figure 4-1 – Tape Loading and Threading – Right Side View