3DMakerWorld Artifex 2, Build Instructions

Page: 14 / 118

2 PACKING LIST
2.3.2 Self-provided tools
•
Metric tape: positioning Z-axis upright aluminum extrusions, leveling X-axis rails
•
Phillips screw driver: PSU cover screws
•
Slotted screw driver: electronics MOSFET connector screws
•
Wire-cutting plier: cutting zip ties and GT2 timing belts
•
Paper towel: wiping oil off shafts, and clean print surface
•
91% rubbing alcohol: clean print surface (not needed in the build process)
2.4 Printed Parts
The printed parts are divided into five sections: lower frame, upper frame, extruder, heated
building platform, and LCD controller sections. Parts in each section are numbered based
on the top-to-bottom, front-to-rear, and left-to-right order. (Figure 2.4)
2.4.1 Lower Frame
•
100 YEndFront
•
101 FrontPanel
•
102 LowerVertexFrontLeft
•
103 LowerVertexFrontRight (same as
102)
•
104 YMotorMount
•
105 PSUFanDuct
•
106 PSUMountBottomFront
•
107 HBPCableFixture
•
108 ElectronicsTopCover
•
109 ElectronicsMount
•
110 PSUCover
•
111 PSUMountBottomRear
•
112 LowerVertexRearLeft
•
113 PowerPanel
•
114 YEndRear
•
115 YIdlerMount
•
116 YEndStopMount
•
117 PSUCableFixture (same as 107)
•
118 USBPanel
•
119 LowerVertexRearRight
2.4.2 Upper Frame
•
200 (S) FilamentGuideTubeMount
•
200L (D) FilamentGuideTube-
MountLeft (same as 200)
•
200R (D) FilamentGuideTubeMoun-
tRight (same as 200)
•
201 ExtruderCableFixtureTop (same as
107)
•
202 ShaftClaspTopLeft
•
203 ZMotorMountLeft
•
204 3DMakerWorldTag
•
205 ZMotorMountRight
•
206 ShaftClaspTopRight (same as 202)
•
207 UpperVertexTopLeft
•
208 UpperVertexTopRight
•
209 (S) SpoolHolder
•
209L (D) SpoolHolderLeft (same as
209)
http: // 3dmakerworld. com
15