2.5.2 Glue part Fuse 2 to the Fuse 1 sub-assembly. Make sure to apply the CA glue
to the mating faces of Fuse 1 and Fuse 1 as well as the portions of Fuse Tray 1
that slide into the rails inside Fuse 2.
NOTE: Because of the stringing of LW-PLA you may need to clean up the
alignmet tabs and alignment holes with a hobby knife
2.5.3 Now glue part Fuse Tray 2 into your assembly just as you did with Fuse Tray 1.
Apply the CA glue to the rails inside Fuse 2 and slide Fuse Tray 2 in place until
fully seated before applying accelerator.
3D
Aeroventures
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
- 1� -
Step-by-Step Build Guide (cont’d)
Make sure to apply CA Glue here as well
