When printing with LW-PLA you will likely have some residual stringing. Inspect
all of the printed parts for stringing and use sand paper, a small file or a hobby
knife to eliminate the stringing, especially in areas where parts will mate. You
will find most of the stringing comes off quite easily.
Step 2.4 Cut or Sand Away Any Stringing
2.3.2 Use the soldering iron to sink qty. 4, M4 x 0.7mm Thread Heat Set Inserts
in place in the wing mounting holes, which are located on the sides of
Fuse 2 and Fuse 3.
3D
Aeroventures
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
- 1� -
Step-by-Step Build Guide (cont’d)
Place M4 Heat-Set
Inserts Here
Fuse 2 (PLA)
Fuse 3 (PLA)
