![3DAeroventures Micro SportCam Build Manual Download Page 16](http://html1.mh-extra.com/html/3daeroventures/micro-sportcam/micro-sportcam_build-manual_442110016.webp)
Tire- TPE
Nose Gear Tire Hub 1 (PLA)
Nose Gear Tire Hub 2 (PLA)
2.4.3 If you choose the tricycle gear configuration, print out the drawing of the nose
gear wire located on the following page to aid in bending a 1mm - 1.2mm
diameter steel wire to the proper shape.
2.4.4 Nose Gear Tire Hub 1 and Nose Gear Tire Hub 2 are designed to be inserted into
each open side of the Tire-TPE component. Insert Nose Gear Tire Hub 1 into
one side of the TPE Tire, apply a small amount of CA glue to the mating face of
the hub and insert Nose Gear Tire Hub 2 into the other side of the TPE Tire.
Set the landing gear aside - it will be attached to the model in a later
step during final assembly.
2.4.5 Slide the Nose Gear Tire assembly onto
the nose gear wire and hold it in place
with a small wheel collar, or use a heat
gun to shrink a small piece of heat shrink
tubing on the tip of the wire.
3D
Aeroventures
N�v�r S�o� E�p�o�i�g� N�v�r S�o� Q�e�t�o�i�g� N�v�r S�o� P�a�i�g
- 1� -
Step-by-Step Build Guide (cont’d)