8/12/22, 2:53 PM
Руководство пользователя
ru.infocenter.3dsystems.com/figure4jewelry/print/book/export/html/526
54/120
4. Click the
C:\
link in the popup to locate where the le is stored, and transfer the le to the root folder
of your USB drive.
5. Plug the USB drive into your printer; and you will see the screen at the right. Tap
Install
.
. On the printer, ensure that you see the "Update Complete!" screen at the right. If you do not see this,
navigate to the
tab to check if the rmware version has been updated. If it has not, perform
the upgrade again. If the issue persists, contact your reseller.
Подготовка
и
установка
лотка
для
полимера
Направляющие
лотка
для
полимера
The membrane contained within each resin tray is the most fragile component of the Figure 4 Jewelry Printer. It must be handled with care.
Follow all resin-tray guidelines and procedures to avoid membrane damage and failure.
ОПАСНОЕ
ДЛЯ
ЗДОРОВЬЯ
РАЗДРАЖАЮЩЕЕ
ВЕЩЕСТВО
!
ПРИ
РАБОТЕ
С
ЛОТКОМ
ДЛЯ
ПОЛИМЕРА
ИСПОЛЬЗУЙТЕ
ЗАЩИТНУЮ
ОДЕЖДУ
,
ОДНОРАЗОВЫЕ
НИТРИЛОВЫЕ
ПЕРЧАТКИ
И
ОЧКИ
.
CAUTION: If a leak/spill occurs, do not run the machine. UV curing will harden the print material on unwanted surfaces and will make
the material very hard to remove. A nonabrasive cloth and IPA will help clean up any spilled uncured material.
CAUTION: Failure to clean the resin tray of partially cured material will lead to membrane failure and failed prints.
1.
Ожидаемый
срок
службы
лотка
для
полимера
составляет
около
900
построений
.