Configuring Dial-in User Parameters
117
7
In the ISP Selection field, select the service providers that this dial-in user can
access.
8
In the Data Compression field, choose to have data compression active or inactive.
By default compression is disabled. (In order for compression to occur, the other
end of the connection must also have compression active.)
Callback Parameters
This section allows you to enable and configure callback functionality. Callback
occurs when, upon a successful connection of dial-in a user, the LAN Modem
drops the incoming call and places a return call to the dial-in user. In order for
callback to work properly, the client-side device must also have callback active.
To specify your Callback parameters, follow these steps:
1
In the Enable Callback field, check to activate Callback for this dial-in user. By
default, Callback is disabled.
2
In the Callback Telephone Number field, enter the number the LAN Modem will
call back when this dial-in user accesses the LAN Modem.
3
In the Callback Alternate Number field, enter a second telephone to be used for
either Multilink PPP or as a second number to try if the call cannot be established
with the first telephone number.
4
In the Callback Authentication field, check the box to require callback
authentication.
5
In the Callback Username field, enter the username used by the server if callback
authentication is requested by the client.
6
In the Callback Password field, enter the password used by the server if callback
authentication is requested by the client.
7
In the Callback Delay field, enter the amount of time in seconds to wait until the
dial-in user is called back. By default this is set to 10.
WAN Parameters
If you used the Dial-in Wizard to create this Dial-in User profile, these fields should
be left as set by the Dial-in Wizard.
1
LAN Modem WAN IP: If the local LAN Modem WAN link has a static IP address,
enter the WAN static IP address. Otherwise leave these fields as set by the Dial-in
Wizard. If you are using the Advanced dial-in scenario, enter the IP address of the
LAN Modem which is receiving the dial-in call.
2
Remote LAN IP: If the remote site of the WAN link has a static IP address, enter the
WAN static IP address. Otherwise, leave these fields as set by the Dial-in Wizard.
For the Advanced dial-in scenario, enter the IP address of the router which is
dialing into the LAN Modem.
3
Remote LAN Subnet Mask: If the remote site of the WAN link has a static IP
address, enter the subnet mask of the remote LAN. Otherwise, leave these fields
as set by the Dial-in Wizard. If you are using the Advanced dial-in scenario, enter
the subnet mask of the remote LAN.
4
Enter your Primary and Secondary (optional) DNS address as instructed by your
MIS administrator, or as set by the Dial-in Wizard. For the Advanced dial-in
scenario, enter the IP address of the LAN Modem which is receiving the dial-in call.
Summary of Contents for U.S. Robotics 56K Voice
