1148
acl
3Com Switch 7750 Family
Quick Reference Guide
acl
User interface view
Use the
acl
command to apply an ACL to filter Telnet users.
Use the
undo acl
command to disable the switch from filtering Telnet users using the ACL.
acl mode
System view
Use the
acl mode
command to set the traffic classification mode for the device.
acl order
System view
Use the
acl order
command to set the match order for the ACL rules sent to hardware.
active region-configuration
MST region view
Use the
active region-configuration
command to activate the settings of an MST (multiple spanning
tree) region.
add-member
Cluster view
Use the
add-member
command to add a candidate device to a cluster.
address-check
VLAN interface view
Use the
address-check enable
command to enable the address checking function of the DHCP relay
agent.
Use the
address-check disable
command to disable the address checking function of the DHCP relay
agent.
address-check dhcp-relay
VLAN interface view
Use the
address-check dhcp-relay enable
command to validate the dynamic entries generated by the
DHCP relay agent.
Use the
address-check dhcp-relay disable
command to invalidate the dynamic entries generated by
the DHCP relay agent.
address-check field enable
VLAN interface view
Use the
address-check field enable
command to enable checking of the specified field.
Use the
address-check field disable
command to disable checking of the specified field.
address-check no-matched
VLAN interface view
Use the
address-check no-matched enable
command to forbid freely-connected clients to pass DHCP
security check.
Use the
address-check no-matched disable
command to allow freely-connected clients to pass DHCP
security check.
aggregate
BGP view/BGP multicast address family view
Use the
aggregate
command to establish an aggregated record in the BGP routing table.
Use the
undo aggregate
command to disable the function.
am user-bind
System view/Ethernet port view
Use the
am user-bind
command to bind the MAC and IP addresses of a user with a specified port.
Use the
undo am user-bind
command to cancel the binding.
apply as-path
Route policy view
Use the
apply as-path
command to add AS number before original AS path in Router-policy.
Use the
undo apply as-path
command to remove the added AS number.
apply community
Route policy view
Use the
apply community
command to set BGP community attributes in Route-policy.
Use the
undo apply community
command to cancel the BGP community attribute setting .
apply cost
Route policy view
Use the
apply cost
command to configure the route cost value of route information.
Use the
undo apply cost
command to cancel the apply statement.
