1202
nat ftp server
3Com Switch 7750 Family
Quick Reference Guide
nat ftp server
VLAN interface view
Use the
nat ftp server
command to configure a non-standard internal FTP server.
Use the
undo nat ftp server
command to remove a non-standard internal FTP server configuration.
nat outbound
VLAN interface view
Use the
nat outbound
command to associate an ACL with a NAT address pool, and bind the address pool
to an I/O Module, so as to translate the addresses matching the ACL to the addresses in the pool on the I/O
Module.
Use the
undo nat outbound
command to remove the configuration.
nat server
VLAN interface view
Use the
nat server
command to define mapping table entries for internal servers. By using the address and
port number specified by the global-addr and the global-port arguments for an internal server, external users
can access the internal server with the address and port number specified by the host-addr and host-port
arguments.
Use the
undo nat server
command to delete an internal server mapping entry.
nbns-list
DHCP address pool view
Use the
nbns-list
command to configure one or multiple WINS server IP addresses for the DHCP clients of a
global DHCP address pool.
Use the
undo nbns-list
command to remove one or all WINS server IP addresses configured for the DHCP
clients.
ndp enable
System view, Ethernet port view
ndp timer aging
System view
Use the
ndp timer aging
command to set the holdtime of the information in the NDP packets sent by the
local switch, that is, to specify how long a device will hold the NDP packets received from the local device. After
the aging timer expires, the device removes the received NDP neighbor node information.
Use the
undo timer aging
command to restore the default NDP information holdtime.
ndp timer hello
System view
Use the
ndp timer hello
command to set the interval to send NDP packets.
Use the
undo ndp timer hello
command to restore the default interval to send NDP packets.
netbios-type
DHCP address pool view
Use the
netbios-type
command to configure the DHCP clients of a global address pool to be of specified
NetBIOS node type.
Use the
undo netbios-type
command to restore the default NetBIOS node type.
network
Traffic group view
Use the
network
command to configure a network address for the traffic group, so as to add a destination
network segment to the traffic group.
Use the
undo network
command to remove a network address from the traffic group, so as to remove a
destination network segment from the traffic group.
network
DHCP address pool view
Use the
network
command to configure a dynamically assigned IP address range (where IP addresses will be
dynamically assigned to DHCP clients).
Use the
undo network
command to remove a dynamically assigned IP address range.
network
RIP view
Use the
network
command to enable RIP on a specified interface.
Use the
undo network
command to disable RIP on the interface.
network
OSPF Area view
Use the
network
command to enable an interface to run the OSPF protocol.
Use the
undo network
command to disable an interface from running OSPF.
