110
C
HAPTER
4: C
ONFIGURING
P
ATH
B
UILDER
S330/S310 M
ODULES
, P
ORTS
,
AND
A
PPLICATIONS
4
Repeat steps 2 and 3, as desired, to add more addresses to the Bridge Static Table.
■
To view the current Bridge Static Table, select
[1] List Static Table
from the
Bridge Static Table menu.
■
To delete an address from the table, select
[3] Delete MAC Address
from Bridge
Static Table menu and enter the number corresponding to the address you
want to delete. Then enter
y
at the confirmation prompt to delete the selected
address from the Bridge Static Table.
Configuring IP over ATM
In addition to the standard bridging configuration described in the previous
section, you can also configure IP over ATM for the Ethernet 10BASE-T or
10/100BASE-T (PCI Ethernet) port. IP over ATM is a method to pass IP traffic across
an ATM network; it follows RFC 1577 (RFC 2225).
To configure IP over ATM for an Ethernet port:
1
Access the IP over ATM menu for the Ethernet port for which you want to
configure IP over ATM.
a
From the main menu, select
[2] Configuration Management
.
b
Select
[4] Manage IP over ATM
. The Manage IP over ATM port selection menu
appears, as shown in Figure 101.
If you have installed the Ethernet 10/100 module, an additional option appears on
the Manage IP over ATM menu, allowing you to select the PCI Ethernet interface
for IP over ATM configuration.
Figure 101
IP over ATM Port Selection Menu
c
Enter the number corresponding to the Ethernet port for which you want to
configure IP over ATM. The IP over ATM menu for the selected port appears, as
shown in Figure 102.
