3Com OfficeConnect 3CR414492, Getting Started Manual

Page: 28 / 66

2-10 C
HAPTER
2: I
NSTALLING THE
O
FFICE
C
ONNECT
R
EMOTE
812 ADSL R
OUTER
Configuring in DHCP Smart Mode
Windows users have the assistance of the Remote 812 IP
Configuration Wizard.
Configuring in Unconfigured Mode
Windows users have the assistance of the Remote 812 IP
Configuration Wizard, as in DHCP Smart Mode.
You need to enter a static address that agrees with other
addresses on your LAN.
Using the Remote 812 IP Configuration Wizard
The Remote 812 IP Configuration Wizard searches the LAN
for all unconfigured OCR 812s. As each unconfigured unit
is found, the unit’s MAC (Media Access Control) address is
placed in the selection box.
1 For multiple OCR 812s, you can determine which MAC
address belongs to the one you want to configure by
disconnecting the Ethernet cable from the OCR 812 and
running the Remote 812 IP Configuration Wizard again.
The missing MAC Address belongs to that OCR 812.
2 If the Remote 812 IP Configuration Wizard does not find
any unconfigured units, and you are sure your unit is
unconfigured, refer to the chapter on Troubleshooting in
the
OfficeConnect Remote 812 ADSL Router Online User’s
Guide .
3 Select the OCR 812 you want to configure and enter its
LAN IP address and netmask. Click
Set .
Using the Command Line Interface
Macintosh and Unix users (and those configured in Bridge
Only Mode but with alternate VPI/VCI
settings) use the
Command Line Interface (CLI).
1 Connect the console cable provided with the OCR 812 kit
to the router and a Com port on your workstation.
2 Use a terminal emulator program to access the Command
Line Interface, using the following settings:
Bits per second: 9600
Data Bits: 8