3Com NBX, Installation Manual

Page: 42 / 248

42 C
HAPTER
1: I
NTRODUCTION
Green — The card has finished downloading software from the
NCP and all software processes have started successfully.
Amber — A problem with one or more of the software processes
running on the card. The card automatically reboots itself if it
detects a problem with any of its software processes.
■
DSP — Reserved for future use
■
NCP — Network Call Processor communications status
Amber — The card is trying to establish contact with an NCP.
Green — The card has established contact with an NCP.
■
LNK — Ethernet link status
Green — The 10/100 Uplink port is connected to a 10Mb or to a
10/100 Mb hub or switch.
Red — The 10/100 Uplink port is connected to a 100 Mb hub or
switch.
Off — There is no connection to the 10/100 Uplink port.
■
ACT — Ethernet activity
Rapid blink — Data is passing into or out of the card through the
10/100 Uplink port.
■
10/100 Uplink — This RJ-45 Ethernet connector connects the E1 card
to an external LAN hub or switch. You can use this connector to
isolate E1 traffic. If the E1 Digital Line Card is used in a V5000
Gateway Chassis, do not use this connector because the chassis has
an Ethernet connector to connect the chassis to the LAN.
■
Console — This DB-9 connector provides an RS-232 (DCE) TTY
terminal connection for maintenance access.
If you require an alternative (bare wire-end) cable to use with the ISDN
PRI Digital Line Card, contact your 3Com NBX Voice-Authorized Partner.
CAUTION: This equipment does not operate when the main power fails.