3Com NBX, Installation Manual

Page: 100 / 248

100 C
HAPTER
2: I
NSTALLING
S
YSTEM
H
ARDWARE
C
OMPONENTS
Figure 29 V3001R with One Disk and Face Panel Removed
6 Slide the new disk into the empty disk drive bay until you feel it contact
the rear connector. Press firmly until you feel the disk drive seat into the
connector. Attach the disk drive locking bracket.
7 Turn on power to both power supplies, and then install the front cover.
Disk synchronization begins automatically and finishes in approximately
20 hours. The system is operational during the disk synchronization. If
you reboot the system during the synchronization, the system continues
the operation after the reboot.
The status lights on the front of the V3001R indicate disk status. For
detailed information, see
“V3001R System Status LEDs - S1 and S2” on
page 29 .
Powering Your NBX
System
To turn on power to the NBX system and the optional NBX chassis, follow
these steps:
1 Attach a power cord to each unit. For an NBX 100, a V5000, or a chassis,
attaching the power cord applies power to the unit. For a V3000, you
must also press the power button on the back of the unit to the ON
position. For a V3001R, the power buttons on the two power supplies are
located on the front of the unit, behind the face panel.
2 Allow approximately 3 minutes for the system to complete the boot
process.
Examine the status lights (LEDs) on the front panel to ensure that the
system is running properly. For status light descriptions, see:
■
V3000 Analog — Figure 1 on page 22 .
■
V3000 BRI — Figure 2 on page 24 .
■
V3001R — Figure 3 on page 26 .
1
2